Quick Disconnect Couplings - Flipbook - Seite 254
1. Selecting the
Conversion Kit
Remove the oil pan drain plug
and drain engine oil. Measure
the thead on the pan plus with
a thread gauge. The thread
size will determine the specific
conversion kit to be used. Kits
are available in two styles:
1) assembly kits (contain
mounting hardware and hose
assembly), and 2) oil pan
drain fitting and coupling with
mounting bracket (installer
must funish hose assembly).
Hose length in inches (“L“)
is added to the basic part
number when ordering
assembled kits.
2. Installation
Determine the length of hose
required for your vehicle. If
the hose length is not known,
mount the quick disconnect
coupling and bracket and route
the hose from the coupling
bracket to the oil pan drain.
Refer to step 5 for proper
routing, mark and cut the
hose to length. Following step
3 install the hose fittings to
complete the hose assembly.
intall the oil pan drain fitting
(per step 6) and the hose
assembly.
AMER region
Remote Access Conversion
Kit Installation
Pan Plug
Thread Size
Assembled
Kit No.
Hardware
Kit No.
1/2-20
18 x 1.5 mm
14 x 1.25 mm
10 x 1.mm
1 1/4-18
1-18
7/8 - 18
24 x 2.mm
9/16 - 18
3/8 - 18 NPT (Pipe)
1/2 - 14 NPT (Pipe)
3/4 - 14 NPT (Pipe)
F400-L
FF401-L
FF402-L
FF403-L
FF404-L
FF405-L
FF406-L
FF410-L
FF952-L
FF411-L
FF412-L
FF413-L
FF428
FF429
FF430
FF431
FF432
FF433
FF434
FF438
FF453
FF439
FF440
FF441
3. Assembling the Hose
Line
A. Put the socket in vise and
screw hose into socket
counterclockwise until it
bottoms. Back off 1/4 turn.
B. Oil nipple threads and inside
of hose liberally. Use heavy
lube oil.
C. Screw nipple clockwise
into socket and hose. Keep
hose from turning while
assembling nipple. Leave
1/32" to 1/16" clearance
between nipple hex and
socket.
4. Mounting the Coupling
Note: The coupling bracket
should be mounted so that the
coupling valve is located above
the oil level in the crank case.
Make sure that the coupling
is mounted firmly and located
so that it will not be damaged
during normal operation of the
vehicle.
A. Attach mounting bracket to
desired location on vehicle,
preferably near the dipstick.
Screw assembled fitting into
bracket until enough thread
is exposed on opposite side
to assemble and tighten the
quick disconnect coupling.
B. Assemble dust cap and
coupling to mounted hose
fitting. Use pipe thread
sealant. Check for any
leakage after kit is installed.
Danfoss Quick Disconnect Couplings Master Catalog
AF435258198969en-000102
254
