Rubber hydraulic hose and ... - Flipbook - Seite 312
Safety information | Danfoss
Fluid connectors identification
Fluid connectors identification
Measuring Tools: A seat angle gauge, thread pitch gauge and an
I.D./O.D. caliper are necessary to make accurate measurements of
commonly used connectors. Danfoss offers a unique new caliper than
offers the capabilities of both a caliper and a seat angle gauge in one
unit.
FT1341
Identification Tool Kit
I.D./O.D. Angle gauge caliper
Thread pitch gauge
How to measure threads
How to measure sealing surface angles
Female connections are usually
measured by inserting the gauge
into the connection and placing
it on the sealing surface. If the
centerlines of the connection and
gauge are parallel, the correct
angle has been determined.
Use a thread pitch gauge to determine the number of threads per inch
or the distance between threads in metric connections. Place the gauge
on the threads until the fit is snug. Match the measurement to the
charts.
Male flare type connectors are
usually measured by placing the
gauge on the sealing surface. If
the centerlines of the connection
and gauge are parallel, the correct
angle has been determined.
Measure the thread diameter with an I.D./O.D. caliper
as shown. Match the measurements to the charts.
312
EMEA Danfoss rubber hydraulic hose, fitting, tooling and accessories category catalog
