Rubber hydraulic hose and ... - Flipbook - Seite 333
Accessories
Steel protective coil sleeve
900705
Steel protective coil spring
900564
900705 sleeve
Step 1
Follow the appropriate assembly
instructions through the assembly
of one end fitting. Insert one end
fitting in vise.
Step 2
Cut coil length. Coil should be
cut to overall assembly length
“OA” minus the sum of the overall
length of each end fitting. (“A”
dimension).
900564 spring
Step 3
3a) 900705 Steel Protective Coil
Sleeve
3a) The hose and the coil should
be held straight. Taping or
capping the
hose end can prevent frayed
wire ends from snagging on
the coil. Bend one end to the
coil outward to form a slight
tab to assist grasping.
(Cut off or bend back when
installation is complete.) Hold
the tab with the thumb of
one hand while twisting the
coil clockwise approximately
one foot back from the coil
tab. When the coil opens up
sufficiently, slip the tab end to
the coil over the hose. Move
the coil onto the hose by
pulling at the tab end while
pushing with the other hand.
Be careful not to exceed
the resiliency of the coil by
stretching it too far.
Step 4
Proceed with assembly of second
end fitting.
3b) 900564 Steel Protective Coil
Spring
3a) Slide coil over hose.
Plastic coil sleeve
900952
Step 1
Follow the appropriate hose
assembly instructions through
the assembly of both end fittings.
Insert end fitting in vise.
Step 2
Cut coil length. Coil should be
cut to overall assembly length
“OA” minus the sum of the overall
length of each end fitting. (“A”
dimension).
Step 3
Wrap the coil on the hose.
EMEA Danfoss rubber hydraulic hose, fitting, tooling and accessories category catalog
333
Danfoss | Safety information
Accessories
