Rubber hydraulic hose and ... - Flipbook - Seite 334
Safety information | Danfoss
Accessories
Accessories
Firesleeve
624
A
B
Step 1
Step 2
Step 3
Step 4
Follow the appropriate hose
assembly instructions through
the assembly of one end fitting.
Cut firesleeve to same length as
hose; using Firesleeve End Dip
(AE13702–003) dip ends of firesleeve
to a depth of three quarters of
an inch and allow to dry at room
temperature.
Skin sleeve back from cut end of
hose enough to allow assembly of
second end fitting. (2A)
Insert tail of band clamp into hand
clamping tool.
Position band clamp over sleeve as
shown and then draw tight with
hand tool. Remove tool and cut
free end of band clamp. Repeat on
other end of assembly. To complete,
bend protruding tail of clamp over
clamp buckle. Also repair any scuffs
or minor abrasions of firesleeve
by brush application of End Dip
AE13702–003.
Then center sleeve so that it
completely covers both sockets.
(2B)
Start firesleeve over cut end of hose.
NOTE: If applying sleeve over
PTFE or stripped cover assemblies,
wrap exposed wire with tape.
Grasp sleeve and slip over the hose
assembly as illustrated.
334
EMEA Danfoss rubber hydraulic hose, fitting, tooling and accessories category catalog
